Filter
Top Products
8
Rear Side/ Right Side/ Bottom Surface
Controls and Features
q Connector Panel
For details, refer to ‘Connector Panel’. (☞ page 9)
w Speaker
Built-in speaker located here.
e Lamp Cover
Remove this cover when replacing the lamp. (☞ page 47)
r Exhaust Vent
Warm air is expelled through these vents to keep the sys-
tem cool. Please do not block the exhaust vents.
t Remote Sensor (Rear)
When operating with the remote control, aim it towards this
sensor. (☞ page 18)
•A remote sensor is also provided at the front of the pro-
jector.
y Front Adjustable Foot (for adjusting the height and
angle)
It is set at the lowest position when shipped from the fac-
tory. The foot can be adjusted to a maximum angle of +6°
and a maximum length of 31 mm. (☞ page 15)
u Filter
Cleans air drawn in from the air inlet. Please clean the filter
regularly with e.g., a vacuum cleaner. (☞ page 50)
i Rear Fixed Foot
7 Air Inlet
Bottom Surface
Blocked as it is not in use.
Opening it forcibly will cause
damage to the machine.
i Rear Fixed
Foot
y Front Adjustable
Foot
r Exhaust Vent
t Remote Sensor (Rear)
e Lamp Cover
q Connector Panel
w Speaker
u Filter
7 Air Inlet
HX-1E_p05-14_En.p65 10/3/03, 6:07 PM8