Filter
Top Products
E-41
Basic Operation
■ How to Quit
1 Turn the lamp off.
Press the POWER button. (Hold down for at least one
second.)
“Press POWER button again to turn off.” is displayed on the
projected image.
Press the POWER button again.
The LAMP/COVER LED blinks green, and then goes out after
about one minute.
The ON/STANDBY LED lights (red.)
NOTE
The lamp will not turn on even if you press the POWER button if the LAMP/COVER LED is blinking green.
To turn the lamp on again, press the POWER button again after the ON/STANDBY LED lights red.
2 Disconnect the power cord.
The ON/STANDBY LED on the operation panel goes out.
CAUTION
• Do not disconnect the power cord before the lamp goes off or the LAMP/COVER LED lights. Doing so may
shorten the life of the lamp.
• Disconnect the power cord from the power outlet if you are not going to use the projector for a long period of time.
• After disconnecting the power cord from the power outlet, wait a certain period of time (about 10 seconds) before
connecting it again.
Remote Control Operation
Main Unit Operation
POWER
2
1
POWER
ON/
STANDBY
LAMP/
COVER
TEMP