Filter
Top Products
NovaJet 500/630/700 Series Service Manual
ASSEMBLY/
DISASSEMBLY
Assembly\Disassembly 5-29
15. Fit the Compression Spring over the post at the back of the Y-
Arm Assembly.
16. Fit the notch in the front end of the Frame Tensioner over the
notch in the front of the Y-Arm Assembly.
17. Depress the back of the Frame Tensioner and slip the Carriage
Belt over the Servo Motor pulley. Make sure that the guides in
the Carriage Belt are properly fitted over the Servo Motor pulley.
18. Gently move the Carriage Assembly from end to end and make
sure that the Carriage Belt is not rubbing against any other
parts.
Remove the Carriage PCB
Integrated circuits may become weakened or damaged
by electrical discharge. Do not touch or work near inte-
grated circuits without wearing an ESD wrist strap.
1. Perform the Carriage Assembly, Carriage Belt, and the Frame
Tensioner Removal procedures to remove the Carriage Assembly
from the Slide Shaft.
2. Put on an ESD wrist strap.
3. Unlock the connectors and remove all flex cables on the Carriage
PCB.