Filter
Top Products
NovaJet 500/630/700 Series Service Manual
ASSEMBLY/
DISASSEMBLY
Assembly\Disassembly 5-31
Failure to use an approved antistatic bag for storage
or shipment may cause damage to the Carriage PCB
and affect the Warranty.
6. Place the Carriage PCB in an ESD bag (antistatic bag) in
preparation for shipment to ENCAD for replacement or repair,
or if it is to be stored at your facility for repair.
Install the Carriage PCB
1. Put the tab on the left end of the Carriage PCB into the slot in
the left side of the Carriage Assembly. See Figure 5-17.
2. Ensure that no flex cables are underneath the Carriage PCB.
3. Push down the right end of the Carriage PCB until the latch
snaps into place.
4. Reattach all flex cables on the Carriage PCB.
5. Perform the Install the Carriage Assembly, Carriage Belt, and
the Frame Tensioner procedures to reinstall the Carriage
Assembly.
Remove the Paper Sensor or the Encoder Sensor
1. Perform the Remove the Carriage Assembly, Carriage Belt, and
the Frame Tensioner procedures to remove the Carriage
Assembly from the Slide Shaft.