Filter
Top Products
5-38 Assembly\Disassembly
NovaJet 500/630/700 Series Service Manual
3. Slide the Carriage Assembly (if installed) to the far left side of the
Slide Shaft. While ensuring a 5” (125mm) overhang on the right
side, position the Trailing Cable over the Stabilizer Bracket and
slowly lower it onto the bracket. Ensure that the Trailing Cable
goes on straight and that there are no buckles in the cable. Firmly
press the Trailing Cable Assembly onto the tape to secure it into
position.
4. Connect the right end to the MPCB at the J6 location.
5. Tape the ferrite to the Trailing Cable approximately 1/4” (6mm)
from the left side of the side plate.
6. If the Carriage Assembly is not installed, perform steps 5 through
18 of the Install the Carriage Assembly, Carriage Belt, and the
Frame Tensioner procedures.
7. If the Carriage Assembly is installed, insert the Trailing Cable
Assembly into the Strain Relief Assembly. Insert the Strain Relief
(with Trailing Cable) onto the Carriage Assembly by sliding it onto
the Strain Relief Support until it snaps firmly into place.
Remove the Stabilizer Bracket and Encoder Strip
1. Perform steps 1 through 13 of the Remove the Left, Top, and Right
Covers procedures to remove the Left, Top and Right Covers.
2. Perform steps 2 through 6 of the Remove the Ink Delivery System
procedures to remove the Ink Delivery System.
3. Perform the Remove the Carriage Assembly, Carriage Belt, and the
Frame Tensioner procedures to remove the Carriage Assembly from
the Slide Shaft.
4. Perform steps 3 and 4 of the Remove the Trailing Cable Assembly
procedures to remove the Trailing Cable Assembly.
5. Remove the Support Bracket by slightly tilting the top of the
Support Bracket towards the front of the printer and lifting it
straight up. See Figure 5-23.