Filter
Top Products
A-62032 November 1996 D-1
Appendix D Maintenance
Before conducting any maintenance procedures, follow these
precautions:
— Before beginning the maintenance procedures, be sure to turn
OFF the power ON/OFF switch and unplug the printer’s
power cord.
— Do not put any equipment that produces a magnetic field near
the printer.
— Do not attempt to remove the units other than those described
in the manual.
Use the mechanical print counter to check the number of prints
made to determine when certain maintenance procedures should
be performed.
Every 75,000 prints
The image transfer/paper separator charger wires should be cleaned
every 75,000 prints. Follow the steps described below to clean the
unit. Before cleaning the wire, be sure to turn OFF the power ON/
OFF switch and unplug the power cord.
Cleaning the image transfer/paper
separator charger wires
1. Open the front cover. Release the lock of the vacuum unit
release lever (M2) and lower the vacuum unit. Push down on
the front edge of the image transfer/paper separator charger
and pull the charger out of the printer.
Mechanical
Print Counter