Filter
Top Products
1.1. Positioning the Printer
1-1
Chapter 1
Installing the Printer
This chapter explains how to unpack and install the printer. The topics covered are:
Positioning the printer
Unpacking and inspection
Names of parts
Setting up and interfacing
1.1. Positioning the Printer
Clearance
Allow at least the necessary minimum clearance around the printer (see below). A total space of 92 cm by
61 cm by 138 cm (36 by 24 by 54 inches) is needed.
Places to Avoid
Avoid installing the printer in locations subject to:
❒ Direct drafts of hot or cold air
❒ Direct drafts from outside (Avoid locations near doors leading outside.)
❒ Sudden temperature or humidity changes
❒ Sources of high temperature, for example, near stoves or radiators
❒ Excessive dust
❒ Vibration
❒ Ammonia or other harmful fumes. (If you are planning to fumigate the room, or make liberal use of insec-
ticide, remove the printer first!)
❒ Excessive sunlight or humidity
❒ Lack of ventilation
❒ Low air pressure, e.g., located more than 2000 meters (6500 feet) above sea level
30 cm (12 inches)
40 cm (16 inches)
[20 cm (8 inches) when the
face-up output tray* is not
installed.]
* Optional with the FS-1750
25 cm (10 inches)
60 cm (24 inches)
30 cm (12 inches)