Filter
Top Products
5.5 Indicators and Messages
5-11
0(025<&$5' HUUúú
3UHVV &217,18(
This message appears when an error occurs during access to the memory card using
the PRESCRIBE 2e RWER (ICCD) command or from the printer's control panel. Look
at the error code given in place ofýú ú and refer to the corresponding description given
below. Note that error codes ofýíä and above only result when memory card opera-
tions are done fromthe control panel.
íì:Data or memory card capacity is too large.
• This error code appears if an attempt is made to write more than 32 MB of data
to a memory card or if the capacity of the memory card installed in the printer
is more than 32 MB. Decrease the data being written to the memory card to less
than 32 MB. Note that only the memory card of 32 MB and less can be used by
this printer.
• This error code appears when a data name not existing on the memory card is
specified.
Check the data names on the memory card.
íë:The memory card does not meet specifications. This memory card cannot be used
by this printer. Insert a memory card which can be used by this printer.
(See "Memory Card" of Chapter 2.)
íê:The memory card is not a JEIDA card. Only a JEIDA Ver. 4.2 memory card can
be used by this printer.
íé:The card is an S-RAM or flash card which cannot be used by this printer.
íè:There is no battery in the memory card. Replace the battery in the memory card
with a new one.
íç:The memory card is write-protected. Cancel the write-protection of the memory
card.
íæ:The memory card requires formatting. Format the memory card from the control
panel.
íä:The capacity of the memory card is insufficient. This error code appears when an
attempt is made to write more data on the memory card than available memory.
To halt the writing of data, first stop data transmissions from the computer, and
then the printer's CONTINUE key. Press the FORM FEED key if the messageý
:DLWLQJ will appear in the message display. The message display will return
to readingý 5HDG\.
ìì:The memory card is full of data items. The number of data items which can be
written on the memory card is limited to 127. Pressing the CONTINUE key will
restore the messageý5HDG\ in the message display.
ìê:This is a logical error. Try substituting another flash memory card.
ìæ:The flash memory card cannot be written due to insufficient printer memory.
Either delete unnecessary macros and/or fonts stored in the printer, or expand
the printer's available memory.
ìå:This is a write error. Try substituting another flash memory card. (Error codes
ìê throughýì å apply only to a flash memory card.)
,î) RFFXSLHG This message is displayed when you attempt to use the printer's control panel to
change the environmental settings on the interface from which data are presently
being received.
3URFHVVLQJ
3$5 ),7 $é
),7 (image FITting) flashes to indicate that a loss of raster data occurred when the
data was compressed to be fitted within the currently available memory. Flashingý
),7 extinguishes automatically when the job times out; the printer receives the next
data from the host computer; or if you press any key on the printer's control panel. Try
adding more memory in the printer to prevent this error.
Message Corrective Action