Filter
Top Products
WiBox2100E User Guide 47
6
6
:
:
S
S
e
e
t
t
u
u
p
p
M
M
o
o
d
d
e
e
:
:
S
S
e
e
r
r
v
v
e
e
r
r
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
This chapter explains how to configure the network settings.
Note: Current values display in parentheses.
Server Configuration (Option 0)
The unit’s basic network parameters display when you select Server configuration
(option 0). The IP Address, Set Gateway IP Address, and Netmask fields display
the current values.
IP Address : (000) .(000) .(000) .(000)
Set Gateway IP Address (N)
Netmask: Number of Bits for Host Part (0=default) (0)
Change telnet config password (N)
Network Mode
Select the network mode for the WiBox. Options available are Wired Only, Wireless
Only, and Bridging. (For more information on bridging, see 11: Wireless Bridging.)
Note: The bridging option will be available in firmware version 6.2 and later.
Network Mode <0=Wired Only 1=Wireless Only
2=Bridging<One Host> >:
IP Address
If DHCP is not used to assign IP addresses, enter the IP address manually. The IP
address must be set to a unique value in the network. Enter each octet and press
Enter between each section. The current value displays in parentheses.
IP Address : (000) (000) (000) (000) _
If DHCP is used, the third octet of the IP address sets the BootP/DHCP/AutoIP
options. The following table shows the bits you can manually configure to force the
WiBox to disable AutoIP, DHCP, or BootP. To disable an option, set the appropriate
bit.
Table 6-1. BootP/DHCP/AutoIP options
Options Bit
AutoIP 0
DHCP 1
BootP 2