Lantronix Ethernet Network Card User Manual


 
Setup Mode: Advanced Settings
WiBox2100E User Guide 68
ARP Cache timeout in seconds
Whenever the unit communicates with another device on the network, it adds an
entry into its ARP table. The ARP Cache timeout option allows you to define how
many seconds (1-600) the unit will wait before timing out this table. The default
setting is 600.
ARP Cache timeout in s (1s – 65s; 0s=disable): (600)? _
CPU Performance
Select the WiPort’s performance mode. Higher performance settings require more
energy. Low is 26 Mhz, Regular is 48 Mhz, High is 88 Mhz. The default setting is
Regular.
CPU performance (0=Regular, 1=Low, 2=High): (0) ? _)?
Notes:
If a baud rate of 460 Kbps or 920 Kbps is set, and the high performance mode is
disabled, the operation of the serial channel would be out of the specified error
tolerance, thereby leading to inconsistent speed settings on the two ends of the
serial channel.
Increasing CPU clock speed consumes more power and generates more heat.
This reduces the maximum operating temperature specification. See the
appropriate product brief for details.
Disable Monitor Mode at bootup
This option allows you to disable all entries into Monitor Mode during startup, except
for the ‘xxx’ sequence. This prevents entry using yyy, zzz, xx1, and yy1 key
sequences (only during the bootup sequence). The default setting for Monitor Mode
at bootup is N (No). (See 9: Monitor Mode.)
Disable Monitor Mode @ bootup (N) ? _
HTTP Port Number
This option allows the configuration of the web server port number. The valid range is
1-65535. The default setting HTTP port number is 80.
HTTP Port Number : (80) ? _
MTU Size
The Maximum Transmission Unit (MTU) is the largest physical packet size a network
can transmit for TCP and UDP. Enter between 512 and 1400 bytes. The default
setting is 1400 bytes.
MTU Size: (1400) ? _
Alternate MAC Address
If necessary, enable the alternate MAC address (if specified in the OEM setup
record).
Enable alternate MAC (N) ?