Filter
Top Products
3: Installation
XPress-Pro SW 94000 User Guide 21
Cabling
1. First, ensure the power of the Xpress-Pro SW 94000 switch and end devices is
turned off.
Note: Always ensure that the power is off before any installation.
2. Prepare cable with corresponding connectors for each type of port in use.
Note: To connect two regular RJ-45 ports between switches or hubs, you
need a cross-over cable.
3. Consult Table 3 in previous section for cabling requirements based on connectors
and speed.
4. Connect one end of the cable to the Xpress-Pro SW 94000 switch and the other end
to a desired device.
5. Once the connections between two end devices are made successfully, turn on the
power and the Xpress-Pro SW 94000 switch is operational.