Filter
Top Products
7. Install the RAID controller into an appropriate PCI card slot on the riser card assembly. Then, install
the screw to secure the RAID controller in place.
Figure 36. Installing the RAID controller into the PCI card slot on the riser card
8. Install the riser card with the RAID controller into an appropriate PCI card slot on the system board.
9. Connect the other end of the 400 mm (15.75 inches) mini SAS signal cable to the mini SAS signal cable
connector
1 on the backplane of your server.
Figure 37. Mini SAS signal cable connector on the backplane
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to “Completing the parts replacement” on page 64.
Installing the ThinkServer RAID 700 Adapter
Attention: Do not open your server or attempt any repair before reading and understanding the “Safety information”
on page iii
and “Guidelines” on page 17.
This topic provides instructions on how to install the ThinkServer RAID 700 Adapter (hereafter referred to as
the RAID controller within this topic) and the battery card assembly for this RAID controller.
48 ThinkServer Installation and User Guide