Filter
Top Products
• Resolve conguration conicts
Starting the Setup Utility program
To start the Setup Utility program, do the following:
1. Approximately three minutes after the server is connected to a working electrical outlet, the power
button becomes active. Turn on the server and the POST runs automatically. You will then see the logo
screen. The POST is a set of tests and procedures that are performed each time you turn on your server.
2. Press Del as soon as you see the logo screen. The Setup Utility program opens. If you have set an
administrator password, you must type the administrator password to access the full Setup Utility
program menu. If you do not type the correct administrator password, a limited Setup Utility program
menu is available.
Note: You can also press TAB as soon as you see the logo screen to review the POST process and
information.
3. The Setup Utility program menu lists various items about the system conguration settings. Select the
settings to view or change.
When working with the Setup Utility program, you must use the keyboard. The keys used to perform various
tasks are displayed at the bottom of each screen.
Note: Use the default setting for any item you are not familiar with. Do not change the value of unfamiliar
items or items that are not mentioned in this manual to avoid any unexpected problems. If you cannot turn
on the server because of incorrect BIOS settings, refer to and use the jumpers to clear CMOS and recover
to the factory default settings.
Introduction of the BIOS items
The following tables list all the main menus and items in the Setup Utility program. Some items might vary
because of the BIOS updates.
Notes:
1. Use the default setting for any item you are not familiar with. Do not change the value of unfamiliar
items or items that are not mentioned in this manual to avoid any unexpected problems. If you cannot
turn on the server because of incorrect BIOS settings, use the jumpers on the system board to clear
CMOS and recover to the factory default settings.
2. After updating the BIOS, all the BIOS settings become the default settings of the updated BIOS version.
You need to check and recongure the BIOS settings for your specic needs.
Table 13. The Setup Utility program main menu
Item Description
Main
Set the basic BIOS parameters.
Advanced
Set the advanced BIOS parameters.
PCIPnP Set the PCI parameters.
Boot
Set the boot parameters.
Security Set the security parameters.
Chipset Set the chipset.
Exit
Exit the Setup Utility program.
68 ThinkServer Installation and User Guide