Filter
Top Products
3. Locate the memory slots. See “Locating parts on the system board” on page 70.
4. Open the retaining clips.
Figure 7. Opening the retaining clips
If you are replacing an old memory module, open the retaining clips and remove the memory module
being replaced as shown.
Figure 8. Removing the memory module
5. Position the memory module over the memory slot. Make sure that the notch 1 on the memory module
aligns correctly with the slot key 2 on the system board. Push the memory module straight down into
the slot until the retaining clips close.
Chapter 8. Replacing FRUs 73