Filter
Top Products
Figure 27. Installing the rear fan assembly
7. Connect the rear fan assembly cable to the system fan connector on the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 104.
Installing or replacing a hard disk drive
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important
Safety Information” on page 1
.
This section provides instructions on how to install or replace a hard disk drive.
Notes: If you are installing additional hard disk drives, ensure that your computer is properly congured
to support them.
• If installing ve SATA hard disk drives, ensure that the SATA hard disk drive enablement module (one to
ve hard disk drives) is installed.
• If installing SAS hard disk drives, ensure that the SAS hard disk drive enablement module or the LSI
MegaRAID SAS adapter is installed.
To install or replace a hard disk drive, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
Chapter 10. Replacing FRUs 83