Filter
Top Products
Error messages
Note:
1. In the charts, x can be any character.
2. The version of PC-Doctor referred to here is PC-Doctor for Windows.
Message Solution
0176: System
Security - The
System has been
tampered with.
This message is displayed if you remove the Security Chip and
reinstall it, or install a new one. To clear the error, enter the
BIOS Setup Utility. If this does not solve the problem, have the
computer serviced.
0182: Bad CRC2.
Enter BIOS Setup
and load Setup
defaults.
Checksum of the CRC2 setting in the EEPROM is not correct.
Press F1 to enter the BIOS Setup Utility. Press F9 and then
Enter to load the default setting. Press F10 and then Enter to
restart the system.
0185: Bad startup
sequence settings.
Enter BIOS Setup
and load Setup
defaults.
Checksum of the startup sequence setting in the EEPROM is
not correct. Press F1 to enter the BIOS Setup Utility. Press F9
and then Enter to load the default setting. Press F10 and then
Enter to restart the system.
0190: Critical
low-battery error
The computer turned off because the battery is low. Connect
the AC adapter to the computer and charge the battery, or
replace the battery with a fully charged one.
0191: System
Security - Invalid
remote change
requested.
The system configuration change has failed. Confirm the
operation and try again. To clear the error, enter the BIOS
Setup Utility.
0199: System
Security - Security
password retry
count exceeded.
This message is displayed if you enter a wrong supervisor
password more than three times. Confirm the supervisor
password and try again. To clear the error, enter the BIOS
Setup Utility.
01C8: More than one
modem devices are
found. Remove one
of them. Press <Esc>
to continue.
Remove one of the Modem Daughter Cards. Otherwise, press
Esc to ignore the warning message. If this does not solve the
problem, have the computer serviced.
01C9: More than one
Ethernet devices are
found. Remove one
of them. Press <Esc>
to continue.
Your ThinkPad computer has a built-in Ethernet feature, and
you cannot add another such feature by installing an Ethernet
device such as a Mini-PCI Ethernet Card or an Ethernet
Daughter Card. If this error message is displayed, remove the
Ethernet device that you installed. Otherwise press Esc to
ignore the warning message. If this does not solve the problem,
have the computer serviced.
Chapter3. Solving computer problems 13