Filter
Top Products
NetWare
This chapter describes using your LevelOne Printer Server in the
NetWare environment.
Overview
This section describes how the LevelOne Printer Server functions in the Novell NetWare
environment.
The LevelOne Printer Server fully supports both Bindery and NDS Novell systems, and be
configured as either a NetWare Printer Server or NetWare Remote Printer.
Novell Distributed Printing Services (NDPS) using TCP/IP under NetWare 5 is also
supported. See page 44 for details.
Logical Printers (Ports)
Logical Printers can be used to create a “Virtual” printer. Single port models support 3
logical printers, while multi-port models support 8 logical printers.
The Logical Printers are named L1, L2, and L3; or L1 to L8 on multi-port models. The
names can not be changed.
Configuring NetWare
PCONSOLE or NWAdmin must be used to create new (logical) printers and assign print
queues to the printers. When creating logical printers, NetWare Printer 8 corresponds to
Logical printer L1 on the LevelOne Printer Server, printer 9 to Logical printer L2, and so
on up to printer 15 (logical printer L8).
Configuring the LevelOne Printer Server
The LevelOne Printer Server requires the following data, if logical printers are going to be
used.
Physical Port
Select the parallel port (P1 to P3) for this Logical Printer
String Before
Job
The printer control string (in Hex) to be sent to the printer
before each print job.
String After Job
The printer control string (in Hex) to be sent to the printer
after each print job.
Convert LF to
CR+LF
If ON, LF (line feed) characters are changed to CR+LF
(carriage return + line feed). If OFF, no conversion is
done.
- 27 -