Filter
Top Products
Level One Printer Servers
TCP/IP Configuration
Selecting TCP/IP will display the screen below.
Figure 34: TCP/IP Screen
Data - TCP/IP Screen
IP Address
The LevelOne Printer Server is able to obtain an IP Address
dynamically, using DHCP, Bootp, or rarp. Normally, it will check
these methods in sequence, but each method can be individually
disabled using BiAdmin. (See Chapter 4). For more details on
using Boop or rarp, refer to Chapter 8 - Unix.
• To use a dynamic IP Address leave the IP Address here at
0.0.0.0.
• To use a fixed (static) IP Address, enter an unused IP
Address from the IP Address range used your LAN (or LAN
segment, if routers are installed).
Router (Gateway)
IP Address
If your network segment has a router, enter the router address
here. If there is no router, leave the address as 0.0.0.0.
Network Mask
If the Router is 0.0.0.0, the Network Mask should also be left at
0.0.0.0.
If you have a router, enter the Network mask (Subnet mask) for
the segment to which the LevelOne Printer Server is attached.
Delay before
reconnection
attempts
Sets how long the LevelOne Printer Server should wait before
retrying a TCP/IP connection which is lost.
Allowable values are from 0 to 255 seconds, with 2 as the default.
Number of
reconnection
attempts
Sets how many attempts at reconnection will be made. After that,
the TCP/IP session will be terminated.
Allowable values are from 0 to 255, with 254 as the default.
- 50 -