Lexmark 90P3000 All in One Printer User Manual


 
Warning—Potential Damage: Do not touch any open connector, the
memory device, or the printer in the areas shown while actively
printing, reading, or writing from the memory device. A loss of data
can occur.
3 If the PictBridge connection is successful, then the following message appears on the display: Use PictBridge
Device to choose and print photos. Press OK to select printer default
settings.
4 If you want to change the default print settings:
a Press
OK
to access the PictBridge menu.
b Press the arrow buttons to select the paper source, paper setup, photo size, number of photos per page and
print quality. You can also enhance the quality of graphics. Press
OK
each time you make a selection.
Note: The printer will use the default print settings unless you change the print settings from the camera.
5 See the documentation that came with the camera to begin printing.
Note: If you insert the USB cable of the PictBridgeenabled camera while the printer is performing another job, then
wait for the job to finish before printing from the camera.
Printing on both sides of the paper (duplexing)
Printing on both sides of the paper (duplexing) automatically
The automatic duplex unit supports A4, A5, letter, legal, statement, and executivesize paper.
Notes:
Other paper sizes may be supported.
Two-sided printing is not supported on envelopes, card stock, or photo paper.
Do not remove the page until printing is finished.
For Windows users
1
With a document open, click File > Print.
2 Click Properties, Preferences, Options, or Setup.
3 Navigate to:
Layout tab > Print on Both Sides (Duplex) area > select Print on both sides
4 Click OK to close any printer software dialogs.
5 Click OK or Print.
Printing 50