Filter
Top Products
76
Print material misfeeds or
multiple feeds occur
(continued).
Make sure the paper width and length guides on the paper sources are
adjusted correctly.
Do not overfill the paper sources.
Do not force print material into the multipurpose feeder when you load it;
otherwise, it may skew or buckle.
Remove any curled print material from paper sources.
Load the recommended print side correctly for the type of print material you
are using. See Loading print material for more information.
Load less print material in the paper sources.
Turn the print material over or around and try printing again to see if feeding
improves.
Do not mix print material types.
Do not mix reams of print material.
Remove the top and bottom sheets of a ream before loading the print
material.
Load a paper source only when it is empty.
Envelope misfeeds or
multiple feeds occur.
Remove the stack of envelopes from the envelope feeder. Load one
envelope, feed it through the printer, and then reload the stack of envelopes
in the envelope feeder.
Page breaks in unexpected
places.
Check the Print Timeout setting in the Setup Menu. Increase the setting.
Job prints from the wrong paper
source or on the wrong print
material.
Check the Paper Type setting in the Paper Menu from the printer operator
panel and in the printer driver.
Paper does not stack neatly in
the output bin.
• Make sure the paper bail is installed.
• Turn the paper stack over in the tray or multipurpose feeder.
Printer does not duplex pages. • Make sure Duplex is selected in both the Finishing Menu and in the printer
driver.
• Make sure you have enough printer memory installed.
Problem Action