Filter
Top Products
CPU Switch Smart SUN-MAC-PCInstallation and Use Page 22
restore lost mouse movement using the CPU Switch Smart SUN-MAC-PC's mouse
restoration functions.
Mouse restoration functions should be used with care as unpredictable
results may occur if the wrong mouse type is selected. If in doubt restore the
mouse by powering down the PC normally.
Standard PS/2 mouse data uses a different data format to IntelliMouse data and so
two reset functions are provided on the CPU Switch Smart SUN-MAC-PC. The type
of data format expected by the PC depends upon the driver and the type of mouse
that was connected when the driver was booted. The following table may be used as
a guide.
Note that the mouse reset functions predict the likely mouse resolution settings but
may not restore the speed or sensitivity of the mouse exactly as they were when the
PC originally booted.
Type of mouse / system Driver type Likely expected Suggested
Connected at bootup data format restoration
PS/2 PS/2 only PS/2 F5
PS/2 IntelliMouse PS/2 F5
IntelliMouse / CPU Switch Smart PS/2 only PS/2 F5
IntelliMouse / CPU Switch Smart IntelliMouse IntelliMouse F6
To restore lost mouse movement on a CPU connected to the CPU Switch Smart
SUN-MAC-PC:
1) Select the CPU that has lost its mouse movement
2) Press the select key on the front of the CPU Switch Smart SUN-MAC-PC for 5
seconds until ‘C’ is displayed. You are now in configure mode.
3) To restore a PS/2 mouse connection press
F 5F 5
ff
Or, to restore an IntelliMouse connection press
F 6F 6
ff
4) Exit from configure mode by typing
E E
ff