Filter
Top Products
30
Chapter 5: Configuring the Network Attached Storage
The Administration Tab - Status
EtherFast Network Attached Storage (120GB with PrintServer)
Click the Restart Now button to restart (reboot) the Network Attached Storage. This will break all existing
connections. The Network Attached Storage will immediately restart and won’t be available again until after the
restart is complete. Any new settings you may have entered will not be saved.
Click the View Log button to view the log file in a separate window. The log file is a record of the Network
Attached Storage’s activities, so it may help with management and troubleshooting. Click the Refresh button to
refresh the screen. Click the Clear Log button to clear all of the log entries.
Printer
Current Status. The possible states are On-line, Off-line, and Out of Paper.
No. of Print Jobs. This is the total number of print jobs in the print queue.
Click the Delete Current Job button to clear the current print job; the following print jobs will remain in the print
queue and be printed.
Click the Delete All Jobs button to clear all print jobs from the print queue.
Disk
Disk 1. This shows the type of hard drive located in the first bay of the Network Attached Storage (the description
is provided by the manufacturer). The amount of disk space available to users is also shown.
Disk 2. This shows the type of hard drive located in the second bay of the Network Attached Storage (the
description is provided by the manufacturer). The amount of free disk space available to users is also shown.
E-Mail Alerts
Send E-Mail alerts when problems are detected. If you want the Network Attached Storage to send e-mail
alerts, then click the checkbox. Alerts will be sent when there is a problem requiring the Administrator’s
attention.
E-Mail Address (1) and (2). Enter the e-mail addresses that should receive e-mail alerts.
Subject. Enter the text you want used as the subject heading for e-mail alerts.
Click the Save button to save any changes. Click the Cancel button to clear any settings that you have entered.
Click the Refresh button to update the data shown on the screen. Click the Details button to open a new window
that displays additional details, including a list of all PCs and other devices that have been allocated IP addresses
by the DHCP Server function (if enabled). Click the Help button to get more information about this screen
Figure 5-14: Log File Screen