Filter
Top Products
16
Chapter 7: Configuring the 10/100/1000 Gigabit Network Adapter in Windows XP or 2000
Adapter Configuration
10/100/1000 Gigabit Network Adapter
Resources
To change the setting of a resource, select a Resource type. Then click the Change Setting button. Select the
new setting, and click the OK button. If you want to use the automatic setting, click the checkbox next to Use
automatic settings, and click the OK button.
Power Management
If you want to allow the computer to power down the Adapter for energy-saving purposes, click the checkbox
next to Allow the computer to turn off this device to save power.
If you want to allow the Adapter to bring the computer out of standby mode, then click the checkbox next to Allow
this device to bring the computer out of standby. If this feature is enabled and your computer is using Windows
XP, another feature will be available; click the checkbox next to Only allow management stations to bring the
computer out of standby if you want to enable this feature.
When you have finished, click the OK button to save any changes.
Figure 7-5: Resources Tab for Windows XP or 2000
Figure 7-6: Power Management Tab for Windows XP