Filter
Top Products
Fast Ethernet Switched 10/100 Network In a Box
24
Instant EtherFast
®
Series
23
Installing the LAN Card Driver if Networking is Already
Installed
The following steps will install the EtherFast
©
10/100 LAN Card’s driver soft-
ware on your PC, enabling your PC to properly communicate with the card.
Remember that you must be logged on as a network administrator (or as a
user with administrative rights) to continue.
1. Click on Start, Settings, Control Panel, then double-click on the
Network icon.
2. When the networking window appears, choose the Adapters tab. Click the
Add button.
NNoottee::
For information
and help on choosing
your bindings, services
and protocols, ask your
network administrator,
or check your Windows
NT documentation.
13. Click Finish. When asked if you want to restart your computer, remove
the Driver Disk and click Ye s .
14. Once your PC has rebooted and you are logged in, double-click the
Network Neighborhood icon on your desktop. Ensure that you have
access to the network. If you do, your card has been properly installed.
• If you had previously installed any NT service packs, you must go back
and re-install those service packs now.
• If you need to install the TCP/IP protocol, refer to your system adminis-
trator or your Windows NT documentation. Linksys does not provide
technical support for the configuration or troubleshooting of the TCP/IP
protocol
The Windows NT Installation and Setup of the EtherFast
®
10/100 LAN
Card is complete. Do not continue on with the next set of instructions.
They are for Windows NT users who already had their networking con-
figured. Return now to the section called Installing the Workgroup Switch
to complete the installation of your Network In A Box.
NNoottee
: If you had previously installed any NT service
packs, you must re-install them. Otherwise, you may
receive Not Enough Service Storage Space errors in
the Event Viewer.