Filter
Top Products
Fast Ethernet Switched 10/100 Network In a Box
40
Instant EtherFast
®
Series
39
Troubleshooting
Troubleshooting hints for Windows can be found below. If you are using
Windows NT, NetWare, or another network operating system, skip to the
LAN Card’s Diagnostics section.
Troubleshooting for Windows 95, 98 and Millennium
1. Windows doesn’t detect new hardware with the EtherFast
®
10/100 LAN Card
hardware installed, or it continues to detect the card each time you restart your PC.
• You might not have inserted the PCI card correctly or securely into the
appropriate slot of your computer. Check that the card is securely inserted
into the appropriate slot.
• Try inserting your card into an alternate PCI slot.
• You may have previously aborted a new hardware setup. Refer to the sec-
tion Starting Over in Windows 95, 98, Millennium, and 2000.
• The motherboard in your system might not be Plug-and-Play compatible,
your PC’s Plug-and-Play settings may not be enabled, or the motherboard
may have Plug-and-Play options not supported by Windows 95/98. If you
are not sure, contact your PC’s manufacturer.
2. Windows can’t locate the driver for the EtherFast
®
10/100 LAN Card.
• You may have inserted the wrong diskette into your PC’s drive.
• The diskette may be defective or files may be missing. Make sure the disk
has a few files in a:\ starting with LNE100 or a folder called Win95 for
Window 95 or Win98 for Windows 98
3. The Windows Logon screen doesn’t appear after you restart your computer.
• Click on Start, Shut Down, then Close All Programs and Logon as a
Different User, (in Windows 98, select Log Off). If this doesn’t solve the
problem, your PC’s manufacturer may have disabled Windows’ networking.
Contact your computer’s manufacturer for help.
4. After entering a username and password, a window appears that reads, “No
Domain Server could be found to validate your Username and Password.”
• Click on Start, Settings, Control Panel. Double-click on Network. Click on
the Configuration tab. Under The Following Network Components are
Installed box, highlight Client for Microsoft Networks and click on the
Properties button. Once you are in the Client For Microsoft Networks
Properties window, make sure that Log on to Windows NT Domain is
unchecked. Once you have made sure that it is unchecked click on the OK
button and restart your computer.
15. Your PC will examine the network. This may take a few minutes.
16. You may be prompted several times for a network on which to bind IPX
to LNE100_1. Accept the default numbers if you are not sure which val-
ues to assign.
17. When asked Do you want to select an additional Network driver?, high-
light No and press Enter.
18. Press ESC a few times to exit the program.
The loading and binding are complete. The server is ready.