Filter
Top Products
Windows NT 4.0
Installation and Setup
Overview
After installing the HomeLink
®
hardware in your computer, follow these
instructions for installing the network driver in Windows NT 4.0. The installa-
tion procedure for the network driver may vary slightly depending on the ver-
sion of Windows NT you are using, the service packs you have installed, and
your current system configuration.
1. From the Windows NT desktop, click on Start, and select Settings and
Control Panel. Double-click on the Network icon.
2. If you have not installed Windows NT networking on your computer, a mes-
sage appears that reads, Windows NT Networking is not installed. Do you
want to install it now?
• If you see this message, click the Ye s button to install NT networking along
with the HomeLink
®
card’s network driver, and continue with step 1 on the
next page.
• If you don’t see this message, NT networking is already installed. Continue
on with Step 1 in this section’s Installing the Network Driver.
Installing Windows NT Networking (Along with the Driver)
Phoneline 10M Network Card
15
8. Windows will finish installing the software onto your PC. Click the
Finish button.
9. When asked if you want to restart your PC, remove the Driver CD and
click the Ye s button.
10. If Windows does not ask you to restart your PC, click the Start button,
choose Shut Down, Restart, then click the Ye s button.
The Windows 98/ME driver installation is complete.
Consult your network administrator for your
network configuration information if necessary.
Linksys HomeLink
®
Series
14