Filter
Top Products
Windows 2000
Installation and Setup
Overview
After physically installing the Phoneline 10M
Network Card in your computer, follow these
instructions to install the network driver. The
installation procedure for the network driver will
vary slightly depending on which version of
Windows 2000 you are using, and on your cur-
rent system configuration. If at any time during
the installation you encounter problems, consult
the Troubleshooting section.
1. Start your computer and Windows 2000. Log in if you are asked to with
administrator’s rights.
2. Windows will display the Found New Hardware Wizard box. Click the Next
button. Insert the HomeLink
®
Card CD into your CD-ROM drive.
Installing the Driver in Windows 2000
Overview
NNoottee::
Prior to
proceeding,
make sure that
you are operat-
ing Windows
2000 with administrative
rights. If you log into Windows
2000 without administrative
rights, you may run into prob-
lems during the installation.
23
Phoneline 10M Network Card
Since NT Networking is already installed, you'll only need to install the
HomeLink
®
Card driver and configure your network settings to get NT net-
working up and running. To do this:
1. Click on the Start button, select Settings, Control Panel, and then double-
click on the Network icon.
2. When the networking window appears, click on the Adapters tab. Click on
the Add button.
3. When the list of available network adapters appears, click the Have Disk but-
ton.
4. Put the HomeLink
®
Installation CD into your CD-ROM drive. Type D:\ into
the box on your screen and click the OK button. NT will copy the necessary
network drivers to your computer.
5. When Linksys Phoneline 10M Network Card Driver appears in the adapter
box, click the OK button.
6. NT will probably ask you to supply your original Windows NT CD-ROM or
setup disks. Supply them as needed.
7. NT may ask you to choose a media type or type of cabling for the HomeLink
card. If so, choose the AutoDetect option and click on the Continue button.
8. When the Network window reappears, click on the Bindings tab. Choose
your bindings. Click on the Protocols tab and select your settings. Do the
same for the Services tab. After your bindings, settings, and services are set,
click the Close button. Choose to restart your PC.
After your computer restarts, the network setup is complete. To see the rest of
the network, double-click on the Network Neighborhood icon that resides on
your NT desktop.
Linksys HomeLink Series
22
Installing the HomeLink
®
Network Driver
if Networking is Already Installed