Filter
Top Products
Power The Power LED will light up when the HomeLink
Phoneline Router is powered on. Note that there is no
ON/OFF switch; simply plug in the power adapter.
The LAN Indicators
Link/Act Green. The Link/Act LED serves two purposes. If the
LED is continuously illuminated, the HomeLink
Phoneline Router is successfully connected to a device. If
the LED is flickering, the Router is actively sending or
receiving data over that port.
Full/Col Green. The Full/Col LED also serves two purposes. If
this LED is continuously illuminated, the connection is
successfully running in Full Duplex mode. If the LED is
flickering, the connection is experiencing collisions.
Infrequent collisions are normal. If this LED is flickering
too often, there may be a problem with your connection.
Check the Troubleshooting section if you think there is a
problem.
100 Orange. The 100 LED illuminates when a successful
100Mbps connection is made through the corresponding
port.
Linksys HomeLink™ Series
5
Phoneline 10M Cable/DSL Router
6
The HomeLink Phoneline Router’s Front Panel LEDs
The WAN Indicators
Link Green. The Link LED illuminates when a successful
connection is made between the HomeLink Phoneline
Router and your Broadband device or network.
Act Green. The Act LED flickers when the HomeLink
Phoneline Router is sending or receiving data over the
broadband port.
Diag Red. The Diag LED illuminates when the HomeLink
Phoneline Router goes through its self-diagnosis mode
during boot-up. It will turn off upon successful comple-
tion of the diagnosis. If this LED stays on for an abnor-
mally long period of time, refer to the Troubleshooting
section.
The HPNA Indicators
Link A Link LED will light up when the port successfully
connects to your phoneline network.
Act Green. The Act LED flickers when the HomeLink
Phoneline Router is sending or receiving data over the
HPNA port.
Col If the Col LED is flickering, the connection is experienc-
ing collisions. Infrequent collisions are normal. If this
LED is flickering too often, there may be a problem with
your connection. Check the Troubleshooting section if
you think there is a problem.