Linksys SRW224G4 Switch User Manual


 
36
Chapter 5: Using the Web-based Utility for Configuration
Port Management Tab - Port Settings
WebView Switches
Recurring. If you selected Other for the Daylight Saving setting and daylight savings has the same start and end
dates and times every year, then select Recurring.
From. If you selected Recurring, then enter the date and time when daylight savings begins.
To. If you selected Recurring, then enter the date and time when daylight savings ends.
SNTP Servers
Server1. Enter the primary SNTP server here.
Server2. Enter a secondary SNTP server here.
SNTP Polling Interval (60-86400). The value defined here determines the amount of time (in seconds) before
the Switch polls the SNTP server. The default value is every 1024 seconds (approx. 17 minutes).
Click the Save Settings button to save your changes or click Cancel Changes to discard the information.
Port Management Tab - Port Settings
The Port Management - Port Settings screen shows you the settings for each of the Switch’s ports.
Port. The number of the port. To use an SFP module, click on the Detail button of the appropriate port (G1, G2).
Description. Displays a brief description of the port (can be entered by clicking on the Detail button).
Administrative Status. The port can be taken offline by selecting the Down option. When Up is selected, the port
can be accessed normally.
Link Status. Up indicates a port has an active connection, Down indicates there is no active connection or the
port has been taken offline by an Administrator.
Speed. The connection speed of the port is displayed here. The speed can be configured only when
auto-negotiation is disabled on that port.
Duplex. This is the port duplex mode, Full (transmission occurs in both directions simultaneously) or Half
(transmission occurs in only one direction at a time). This mode can be configured only when auto-negotiation is
disabled and port speed is set to 10Mbps or 100Mbps. It cannot be configured on Link Aggregation Groups
(LAGs).
Figure 5-5: Port Management - Port Settings