Filter
Top Products
38
Chapter 5: Configuring the Switch through the Web Utility
Switch Config
24-Port 10/100 + 2-Port Gigabit Switch with Webview and Power over Ethernet
VLAN Port
You can configure VLAN behavior for specific interfaces, including the default VLAN identifier (PVID), accepted
frame types, ingress filtering and mode.
VLAN identifier (PVID). VLAN ID assigned to untagged frames received on the interface. (Default: 1)
• If an interface is not a member of VLAN 1 and you assign its PVID to this VLAN, the interface will
automatically be added to VLAN 1 as an untagged member. For all other VLANs, an interface must first be
configured as an untagged member before you can assign its PVID to that group.
Accepted frame types. Sets the interface to accept all frame types, including tagged or untagged frames, or
only tagged frames. When set to receive all frame types, any received frames that are untagged are assigned to
the default VLAN. (Options: All, Tagged; Default: All)
Ingress filtering. Determines how to process frames tagged for VLANs for which the ingress port is not a
member. (Default: Disabled)
• Ingress filtering only affects tagged frames.
• If ingress filtering is disabled and a port receives frames tagged for VLANs for which it is not a member,
these frames will be flooded to all other ports (except for those VLANs explicitly forbidden on this port).
• If ingress filtering is enabled and a port receives frames tagged for VLANs for which it is not a member,
these frames will be discarded.
• Ingress filtering does not affect VLAN independent BPDU frames, such as GVRP or STP. However, they do
affect VLAN dependent BPDU frames, such as GMRP.
Mode. Indicates VLAN membership mode for an interface. (Default: General)
• Trunk – Specifies a port as an end-point for a VLAN trunk. A trunk is a direct link between two switches,
so the port transmits tagged frames that identify the source VLAN. Note that frames belonging to the
port’s default VLAN (that is, associated with the PVID) are also transmitted as tagged frames.
• General – Specifies a hybrid VLAN interface. The port may transmit tagged or untagged frames.
• Access – Is the default setting for all ports.
Fill in the required settings for each interface, click Submit.
Figure 5-17: Switch Config - VLAN Port