Filter
Top Products
SAS2 Integrated RAID Solution User Guide Appendix A: | Commands
LSI Corporation Confidential
| August 2010 Page 41
A.3.11 LOCATE Command The LOCATE command locates a specific drive in a volume by turning on its location
indicator and flashing its LED.
Command Line sas2ircu <controller_#> locate <Enclosure:Bay> <action>
Parameters <controller_#> – The index of the controller with the drives that you need
to locate.
<Enclosure:Bay> – The enclosure and bay number of the drive.
<action> – The possible actions are as follows:
— ON – Turn on the location indicator of the drive.
— OFF – Turn off the location indicator of the drive.
Program Return Value 0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command-line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Cannot find specified adapter.
A.3.12 LOGIR Command The LOGIR command uploads or clears the Integrated RAID log information.
Command Line sas2ircu <controller_#> logir <action> [filename] [noprompt]
Parameters <controller_#> – The index of the controller with the logs that you need to
upload or clear.
<action> – The possible actions are as follows:
— UPLOAD – Upload the controller logs to a file.
— CLEAR – Clear the controller logs.
filename – This optional parameter specifies the filename where the logs must
be uploaded. The default filename is LOGIR.LOG.
noprompt – This optional parameter prevents warnings and prompts from
appearing while the command is running.
Program Return Value 0x00 SUCCESS: Command completed successfully.
0x01 FAILURE: Bad command-line arguments or operational failure.
0x02 ADAPTER_NOT_FOUND: Cannot find specified adapter.