Filter
Top Products
MAGMA
26
4. If the device is currently in the Magma chassis, the location will
show “Magma chassis x slot y”. Where x identifies the physical
chassis and y identifies the physical slot the device is plugged
into.
After verifying that this is the device to be removed, click
on the OK button to close the new dialog.
5. The properties dialog should close and the original “Safely
Remove Hardware” dialog should remain.
Click on the Stop button of the dialog.
6. A dialog with the title “Stop a Hardware device” should appear.
This device is used to confirm that the user wishes to stop this
device.
Click on the OK button of the new dialog.
7. After a brief period a pop up will appear telling the user that the
device may be removed safely, and the device will be removed
from the list of the original dialog.
Press the Attention button that corresponds to the slot
where the device is located.
8. A green LED, labeled PX PwrE (where X
corresponds to the slot number) will begin
to flash.
Note:
If, by mistake, you’ve pressed the
button corresponding to the wrong slot,
immediately let go of the button and the
LED will stop flashing and remain on,
otherwise continue to step 9.
9. After 5-6 seconds the LED will stop flashing
and turn off completely.
Press
and
observe
LED