Filter
Top Products
How to set or change PupPreRec
Quick instructions
Press & hold
MENU/STORE 2 sec ....... Preset
Double Click ENTER
.................. RecFormat
Press F.FWD/+
until ................... PupPreRec
Press ENTER
.....................................Off/On
Press F.FWD/+
........................ toggle Off/On
Example display
3. Press and release
the F.FWD/+
button
until
PupPreRec is displayed.
4. With PupPreRec
flashing, press
and release the
ENTER button
.
PupPreRec menu choice is flashing.
5. Press and release
the F.FWD/+
button
to
toggle between On and Off.
6. When the desired state is displayed, press
and release the
ENTER button
.
The display returns to PupPreRec flashing.
You can:
• Press and release the F.FWD/+ button
or the -/
F.REV button to tab to another menu choice, or
• Press and release the
MENU/STORE button to write
the menu changes and return to stop mode, or
• Press and release the CANCEL button
to cancel all
menu changes and return to stop mode.
St Mode
Stereo Mode determines which input channels
are recorded onto the Left and Right channels.
There are three Stereo Modes:
Stereo - The Left input channel is recorded onto
the Left channel, and the Right input channel is
recorded onto the Right channel.
L-Stereo - The Left input channel is recorded
onto the Left channel, and onto the Right channel.
0-20dB - For secure recording, the Left channel is
recorded at the normal record level and the Right
channel is reduced by 20dB.
Notes:
• If the input is set to INT MIC and St Mode is set to 0-
20dB, the St Mode of the recording is automatically
switched to L-Stereo.
• If a mono source input (INT MIC or L channel only) the
mono input is also recorded on the R channel reduced
by 20dB.
1. From stop, press
and hold the
MENU/STORE
button for about 2
seconds.
2. With Preset
flashing in the
display, double click the ENTER button
.
3. Press and release the F.FWD/+ button
until St Mode is
displayed.
4. With St Mode
flashing, press
and release the
ENTER button
.
St Mode menu choice is flashing.
How to set or change St Mode
Quick instructions
Press & hold
MENU/STORE 2 sec ....... Preset
Double Click ENTER
.................. RecFormat
Press F.FWD/+
until ........................ St Mode
Press ENTER
......... Stereo/L-Stereo/0-20dB
Press F.FWD/+
..................... tab thru modes
Press ENTER
.................................. St Mode
Press
MENU/STORE .................... store & exit
1. From stop, press
and hold the
MENU/STORE
button for about 2
seconds.
2. With Preset
flashing in the
display, double
click the ENTER
button
.
- 36 -