Filter
Top Products
2.2. Disassembly
2.2.1. Preparation
Attention:
Before disassembly, be sure to perform the following steps.
1. End the Windows.
2. Turn off the power and then remove the AC adaptor.
3. Slide the hooks (A) and then remove the battery pack.
4. Remove the screw (A) and then remove the DIMM cover.
(Remove if the DIMM memory is equipped with)
Screw (A) : XSB2+4FNL(N16)
DIMM Cover
Baattrey Pack
Hook(A)
Screw(A)
2.2.2. Removing the Keyboard
Preparation : perform the section 2.2.1. first.
1. Remove the 4 screws (B).
Screw(B):DXQT2+E12FNL(N11)
2. Remove the 2 keyboard hook plates, and then remove the
hook of back side of keyboard with screw driver.
Screw(B)
Screw(B)
Screw(B)
Keyboard Hook Plate
Keyboard Hook Plate
3. The LCD unit is opened up to about 90° by operating the
LCD knob.
4. Remove the 6 hooks (B).
5. Open the keyboard from LCD side and then turn it inside
out on the top case.
Note:
It can remove with the keyboard hook plate.
LCD Knob
Hook(B)
LCD Unit
Hook(B)
6. Remove the heat spreader from buttom of the keyboard.
7. Remove the keyboard FFC from the connector (CN15) and
then remove the keyboard.
Heat Spreader
CN15
KeyBoard
2-2