Filter
Top Products
5. Remove the DC jack holder on the DC-IN jack.
6. Remove the LCD cable connectors (CN10,CN11,CN24).
CN10
CN24
CN11
LCD Cable
7. Turn it to arrow and remove the lithium battery connector
(CN3), LAN cable connector (CN16) and HDD FPC
connector (CN4) and then remove the main board.
CN3
LAN
Cable
CN16
CN600
DC-IN Cable
Lithium Battery
Cable
Tape
Power Knob
LAN SW Knob
2.2.9. Removing the Antenna Board (L,R)
and the DC-IN Cable
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.8.
first.
1. Remove the antenna cable(L) from the main terminal and
the antenna cable(R) from the AUX terminal and then
remove the antenna board(L, R) from the bottom case.
2. Remove the DC-IN cable(CN600) from the main board.
Antenna Cable(L)
Antenna Cable(R)
CN600
DC-IN
Cable
Antenna Board(L)
Antenna Board(R)
2.2.10. Removing the Wireless LAN
Module
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.8.
first.
1. Peel off the tape on the wireless LAN module.
2. Open the wireless LAN module holding arms and remove
the wireless LAN module.
Tape
Wireless LAN Module
Main Board
2-6