Filter
Top Products
2.2.13. Removing the LCD Unit
Preparation : perform the section 2.2.1. to 2.2.3. first.
1. Remove the 2 screws (M).
Screw(M):DXQT26+D5FNL(N14)
2. Remove the LCD cable from the connector (CN11) of the
main board.
3. Remove the inverter cable from the connector (CN10)
4. Remove the touch panel cable from connector (CN24).
CN10
CN24
CN11
Screw(M)
LCD Cable
Screw(M)
2.2.14. Removing the Hinge Cover
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.13.
first.
1. Remove the 2 screws (Q) and then remove the hinge cover
(L,R).
Screw(Q):DRHM0076ZA(N3)
Hinge Cover(R)
Hinge Cover(L)
Screw(Q)
Screw(Q)
LCD Unit
2. Remove the 2 screws (R).
Screw (R):DRHM0076ZA(N3)
Screw(R)
Screw(R)
LCD Unit
2.2.15. Removing the LCD Unit and the
LCD Rear
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.13.
to 2. 2. 14. first.
1. Separate the LCD front and the LCD rear.
2. Remove the hinge (L).
Hook Position
HInge(L)
Hinge(R)
LCD Front
LCD Rear
LCD Unit
2.2.16. Remove the Inverter
Preparation : perform the section 2.2.1. to 2.2.3. and 2.2.13.
to 2. 2. 15. first.
1. Remove the LCD cable from the inverter.
2. Peel off the conductive cloth(LCD cable) from the inverter.
3. Remove the inverter with inverter box.
LCD Hook
Conductive Cloth
(LCD Cable)
Inverter Box
Tape
LCD Cable
LCD High voltage
2pin Wire Rod
LCD Front
2-8