Filter
Top Products
22
Source Selection
The default Source Select for the MDLP1 Projector is the
COMPonent 1 Input. There is an additional Component
Video Input (COMP 2) along with two HDMI Inputs.
Select the desired source using the push-buttons located on
the Projector Control Panel or on the PROJ INPUT Push-
buttons located on the Remote Control. Refer to figures 14
and 15.
Note: Whenever possible use HDMI connections between
the source device output to the MDLP1 Input. This
will yield better image quality, as the video signal
will go through one less analog to digital conver-
sion process and possibly one less digital to analog
conversion process as well.
Image Adjustments and Setting changes
All of the electronic based image adjustments and pro-
cessing settings are performed by using the extensive
On-Screen Menuing System. The
On-Screen Menuing System is in-
teractive and the ability to change
a given setting is dependent on
the Input selected, the presence
of a video signal for that input,
the Picture Mode selected and are
automatically saved for the cur-
rently selected video input. When
a menu item is “grayed out” it
can not be changed until either
another Input is selected, a signal
is present or a different Picture
mode is selected.
The selection of a menu item
and the available choices/adjust-
ments are performed by using the
Navigation (◄LEFT, ►RIGHT,
▲UP or ▼DOWN) Push-buttons
along with the ENTER/SELECT
Push-buttons located on the Pro-
jector Control Panel and/or using
the Remote Control Push-buttons.
The following examples
will illustrate how to use the
On-Screen Menuing System by
performing the Display Installa-
tion Orientation, Display Vertical
Keystone Adjustment and Remote
Control Configuration. All of the
remaining menu options are per-
formed in a similar manner.
How to Operate the MDLP1
Power
The Red LED to the left of the STANDBY/ON Push-but-
ton lights to indicate the MDLP1 is in Standby mode. To
Switch ON the MDLP1, press the STANDBY/ON Push-
button on the Projector Control Panel or the Projector ON
Push-button using the Remote Control. The Green LED to
the right of the STANDBY/ON Push-button lights to indi-
cate the MDLP1 is ON. Refer to figures 14 and 15.
Notes: 1. It is normal for the projector lamp warm up period
to last about a minute before an image appears on
the screen.
2. If the Initial Setup for the MDLP1 has not yet been
performed refer to page 14 at this time.
Figure 14
Figure 15