Filter
Top Products
28
Menu Position - There are nine different positions On-
Screen to display the menus.
Status Info. - Displays On-Screen information about the
status of the video input signal and when
other operational modes are selected. This
occurs when the INFO push-button or other
push-buttons are pressed on the Remote
Control.
Enable: Displays the current status for a set
amount of time in the upper right-
hand corner of the screen.
Disable: The information is not displayed.
Power-OFF Confirm - Displays an On-Screen message
requesting confirmation after press-
ing either the PROJ OFF Push-but-
ton on the Remote Control or the
STANDBY/ON push-button on
the Projector Control Panel (as the
push-button may have been pressed
by mistake).
Disable: Switches Off power to
the projector without the
option provided by the
confirmation message.
Enable: The confirmation message
will appear after press-
ing either push-button to
switch power Off to the
projector.
Blanking Memory - There are three memory locations
capable of storing how much projected
image (top/bottom/sides) will be cut
off by black bands (masking) to pre-
vent viewing the undesirable parts of
the image.
Memory 1-3: Each of the three mem-
ory locations will store
and retrieve the desired
masking settings.
Off: Switches Off the blank-
ing mode Off. No mask-
ing occurs.
Config. Settings
The items in the configuration menu determine how the
MDLP1 Projector interfaces with other equipment, such
as motorized projection screens. There are also settings
dealing with the MDLP1 Projection Lamp. Refer to figure
32 and your McIntosh Dealer for additional information
and/or assistance.
Auto Power Off - This feature allows for the MDLP1 to be
switched Off automatically 10 minutes
after there is a loss of a video signal on
the currently selected input, thus con-
serving the projectors lamp life.
Enable: This setting will activate the
feature. Approximately nine
minutes after there is a loss
of the video signal, an
On-Screen message will
appear. If the MDLP1
doesn’t receive a video
signal on the currently
selected input or a new
command is not issued via
the Control Panel or Remote
Control, the MDLP1 will
switch Off about one minute
later. Refer to figure 33.
Disable: The Auto Power Off Feature is
switched Off.
Tigger 2 - Is activated by changing the Aspect Ratio (Full,
Normal, Zoom, V-stretch and Through). This
allows for changing the size of the reflective
area of the projection screen (via motorized
masking) and/or the addition of an external lens
in the light path. With a given Trigger 2 (Full,
Standard 1
Menu Position
Language
Status Info.
Power-OFF Confirm.
Blanking Memory
Blanking Top
Top-L
English
Enable
Enable
Memory 1
0
0
0
0
Blanking Bottom
Blanking Left
Blanking Right
Picture Adjust
Fine Menu 1
Fine Menu 2
Input Signal
RGB/HD Adjust
Display
OSD/Blanking
Config.
Figure 31
Standard 1
Auto Power Off
Trigger 2 Full
Trigger 2 Normal
Trigger 2 Zoom
Enable
On
On
On
Trigger 2 V-stretch On
Trigger 2 Through On
Reset Lamp Life
Reset All
Remote Control
Picture Adjust
Fine Menu 1
Fine Menu 2
Input Signal
RGB/HD Adjust
Display
OSD/Blanking
Config.
Figure 32
It will be standby mode soon.
Auto Power Off
Figure 33