Filter
Top Products
Logging In
When you start MegaVision, you can log in as user or supervisor. As a user, you can view
network configuration and device status, but you cannot make any changes in the network.
As a supervisor, you can view network configuration and device status, and change
configurations and parameters of network devices. If you are operating multiple NMS
managers in a network, it is recommended that only one manager have supervisor privileges
to avoid conflicts between network changes made from multiple NMS supervisor consoles.
However, there is no automatic limitation for this configuration. Login modes are selected in
the Login window when you load the application.
To Login as a Supervisor
The following directions describe how to log in the first time you enter MegaVision. After this
initial login procedure, you can set up passwords for USER or SUPERVISOR modes, or set
up the Password window to bypass the Login window. At this point the Login window should
already be on the screen. If so, proceed to step 2.
1. Select Login from the Options menu. The Login window appears.
2. In the Login window, choose SUPERVISOR to enter the system in SUPERVISOR
mode.
Figure 1. Login Window
3. Choose OK. If you choose Cancel, MegaVision software is not loaded.