Filter
Top Products
IS1000 – Configuration Guide
iii
TABLE OF CONTENTS
1. INTRODUCTION.............................................................................................................1
1.1. Default Configuration (factory setting)..............................................................3
2. COMMUNICATION MODES...........................................................................................5
2.1. RS232....................................................................................................................6
2.1.1. Baud Rate..................................................................................................6
2.1.2. Data Bits ....................................................................................................7
2.1.3. Parity..........................................................................................................7
2.1.4. Stop Bits ....................................................................................................7
2.1.5. End of Message Character........................................................................8
2.1.6. Time-Out Between Characters ..................................................................9
2.1.7. ACK/NAK Protocol...................................................................................10
2.1.8. XON/XOFF Protocol ................................................................................10
2.1.9. RTS/CTS Protocol ...................................................................................10
2.1.10. PC-Term Mode ........................................................................................11
2.2. Keyboard-Wedge ...............................................................................................12
2.2.1. End of Message Character......................................................................14
2.2.2. Upper / Lower Case Options ...................................................................14
2.2.3. Types of Numeric Characters..................................................................15
2.2.4. Time-Out Between Characters ................................................................15
2.2.5. "WYSE" Time-Out....................................................................................16
2.3. P.O.S. (Point Of Sale) Systems.........................................................................17
2.4. Wand Emulation.................................................................................................18
2.4.1. Transmission Speed................................................................................18
2.4.2. Bar/Space Polarity...................................................................................19
2.4.3. Idle State..................................................................................................19
2.5. Laser Emulation.................................................................................................20
3. SYMBOLOGIES ...........................................................................................................21
3.1. Symbology Selection ........................................................................................22
3.2. Code 39...............................................................................................................24
3.2.1. Standard/Full ASCII.................................................................................24
3.2.2. Full ASCII Extended ................................................................................24
3.2.3. Multiread..................................................................................................25
3.2.4. Modulo 43 Check Character....................................................................25
3.2.5. Pharmacode or Pharma 32/39.................................................................26
3.2.6. CIP Code 39 ............................................................................................26
3.2.7. Start/Stop.................................................................................................27
3.2.8. Modulo 43 Algorithm................................................................................27
3.3. Interleaved 2/5....................................................................................................28
3.3.1. Fixed Length(s) Authorized and Set Upon First Reading(s)....................28
3.3.2. Fixed Length(s) Authorized and Set Using the Numeric Pad ..................29
3.3.3. Variable Lengths Authorized....................................................................30
3.4. UPC/EAN.............................................................................................................31