Filter
Top Products
6
I
NSTALLING THE
S
CANNER TO THE
H
OST
(O
PTIONAL
F
EATURES
)
External Speaker Box Option
When attached, beeper tones from the scanner are emitted from both the
scanner speaker and external speaker to serve as an audible indication of the
operation of the scanner.
There are 6 beeper options available:
Normal Tone Tone 2 Tone 4
Tone 1 Tone 3 No Tone
Beeper tones can be adjusted by using the MetroSet
®
program.
To avoid potential problems, do not power up the scanner until the
communication cable is secured to the host.
1. Turn off the host system.
2. Connect the
communications cable to
the HoloTrak
®
and to the
host.
3. Connect the External
MX008 cable to the
HoloTrak
and the MX008.
4. Check the AC input
requirements of the power
supply for the scanner and
the MX008 to make sure
the voltages match the AC
outlets.
5. Connect the power supply
to the HoloTrak.
6. Plug the power supplies
into the AC outlet.
7. Power up the host system
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet
the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1.
To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC 60950-
1, the power source should meet applicable performance requirements for a limited power source.