Filter
Top Products
14
I
NSTALLING AND
R
UNNING THE
M
ETRO
S
ET
®
2
P
ROGRAM
How to Start
To avoid potential problems, do not power up the scanner until the
communication cable is secured to the host.
1. Turn off the PC after installing the MetroSet 2 program.
2. Connect the communication cable to the scanner and to the RS-232C
serial port (COM1 or COM2) located on the PC.
3. Check the AC input requirements of the transformer to make sure the
voltage matches the AC outlet. An easily accessible socket-outlet
should be installed near the equipment.
4. Power up the scanner.
5. Turn on the PC.
6. From your Start menu choose P
rograms, MetroSet 2, MetroSet 2.
7. Select Holotrak
®
as the unit to configure.
8. Then choose Configure.
9. For detailed instructions on the configuration options available choose
Help from the menu bar.
Metrologic’s HoloSet
®
program can also be used to configure the scanner.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet
the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950-1.
To maintain compliance with standard CSA C22.2 No. 60950-1/UL 60950-1 and norm EN/IEC 60950-
1, the power source should meet applicable performance requirements for a limited power source.