Filter
Top Products
23
Please wait for Writing...block 1
Please wait for Writing...block 2
Replay New Greeting Voice?(y/n):
Disconnect Tone Analysis : please follow instructions on screen (Selection
2). First call in line1 of VoIP FXO gateway from PSTN side (now can’t hear
greeting), hang up the phone and press “enter” to start record disconnect tone.
Finally, choose “y/n” to save data analyzed or not. Notice that system will save
one set of frequency analyzed and 4 set different on/off time in
“busytone1”,”busytone2” ,“reordertone1” , “reordertone2” (Please refer to
tone command) .
If VoIP FXO gateway still can’t hang up call correctly, it could be tone cadence
issue (on/off time). Please count on/off time and configure it into tone
command.
usr/config$ greetrd
==================================================
Welcome to Voice Record/Analysis Mode
--------------------------------------------------
1.Greeting Voice Record.
2.Disconnect Tone Analysis.
3.exit.
--------------------------------------------------
Please input function(1~3): 2
2.Disconnect Tone Analysis.
Please Dial-in "Line 1" and then Hang up the phone!!!
Press "Enter" to start record!!!
Waiting for Disconnect Tone from PSTN....
Disconnect Tone Detected....
Starting Record...
Set parameters to flash? (Y/N)
exit : exit this command
usr/config$ greetrd
==================================================
Welcome to Voice Record/Analysis Mode
--------------------------------------------------
1.Greeting Voice Record.
2.Disconnect Tone Analysis.