Filter
Top Products
37
-t38 T.38(FAX) enabled/disabled.
-fstart Fast start enabled/disabled.
-tunnel H245 Tunneling enabled/disabled.
-h245fs H245 separate channel after faststart.
Example:
support -fstart 1
support -tunnel 0
support -h245fs 1
Parameter Usages:
-print print current setting in support command.
-t38 to switch ON/OFF (1 = ON; 0 = OFF) T.38 function.T.38 function
is for FAX. If user will use FAX machines, please switch on T.38
function.
-fstart to switch ON/OFF (1 = ON; 0 = OFF) FastStart function. Fast
Start function can shorten the connection time if the opposite
party also support FastStart.
-tunnel to switch ON/OFF (1 = ON; 0 = OFF) H.245 tunneling function.
If the function is ON, VoIP FXO gateway will send H.245 (Call
Control messages) via H.225’s (Call Signal messages) link. The
function is effective only when both side support h245 tunnel.
-h245fs to set if open H.245 separate channel after fast start or not. (1 =
ON; 0 = OFF)
Note:
1. it is not recommended to change the value in this command, only if users
do know well the application. This might cause incompatibility with other
devices.
2. If user wants to use T.38 fax under fast start mode, please make sure
“h245fs” function is enabled, or fax can’t work normally.
5.20 [group] command
This command is for grouping ports of VoIP FXO gateway. If users need to
register at least 2 numbers separately to gatekeeper, then this command is
needed for such an application.
usr/config$ group
PSTN side grouping information and configuration
Usage:
group -print | -enable | -disable |
-number group_number -pattern pattern_numbers -e164
e164_numbers |
-pattern pattern_numbers -e164 e164_numbers |
-e164 e164_numbers
Comment:
-print Print current group configuration