Filter
Top Products
30
for response. If the other party cannot respond the message in
10 seconds, VoIP FXO gateway will regard the opposite party as
IDLE state and disconnect the call. When CallAlive is
deactivated, RoundTripDelay message will not be sent during
connection.
- keypad keypad type when relay DTMF signal.
0 : In-Band
1 : h.245 alphanumeric
2 : h.245 signal type
3 : q.931 user info
- pincode To specify 2 sets of pincode.
-sendxcode send access code after connection (1 = ON; 0 = OFF)
-access specify access codes (per port basis).
Note:
1. This feature can only be implemented with LineToLine service. Please
refer to –service above.
2. This function can help users to restrict callers to dial particular
numbers from IP side to PSTN side. For example, if user set
sysconf –access set1 1111, when callers call from IP side and enter
VoIP FXO gateway port 1, if user dial 234 after hearing dial tone, VoIP
will dial out 1111234.
usr/config$ sysconf –sendxcode 1 –access set1 1111
5.14 [h323] command
This command is to configure H.323 related parameters.
usr/config$ h323
H.323 stack information and configuration
Usage:
h323
h323 [-gk ipaddress] [-multicast used] [-e164 number] [-alias h323id]
[-rtp port] [-h245 port] [-ttl time] [-gkfind port] [-ras port]
[-range [start num1] [end num2]]
h323 -print
-print Display H.323 stack information and configuration.
-mode Configure as Gatekeeper mode or Peer-to-Peer mode.
-gk Gatekeeper ip address. (0.0.0.0 ~ 255.255.255.255)
-gkname Gatekeeper ID
-dfgw Default Gateway ip address. (0.0.0.0 ~ 255.255.255.255)
-e164 IP side registered number (phone number).
-alias IP side registered H.323 alias (account name).
-gkdis Gatekeeper auto discovery (On=1, Off=0).
-rtp RTP port number (1024~65532).
-h245 H.245 port number (N/A).
-ttl RAS TTL time (0~3600 second).
-gkfind Gatekeeper finding port (1024~65535).