Filter
Top Products
45 Chapter 3
5. Connect the IDE flat cable to Primary (recommended; CN1 of
mainboard) or secondary IDE connector (CN2 of mainboard), then
connect the other side of the connector to the hard disk. (Refer to
Figure 3.1 for the location of CN1 and CN2)
Figure 3.1: IDE Connector (CN1 and CN2)
6. Re-fasten the upper cover with the eight screws.
Note: When you connect HDD IDE cable to the con-
nector on mainboard, please also pay attention
of the direction. The correct connection way is
shown below, notice the pink line)
CN2
CN1
2