Filter
Top Products
13
B. After both mounting brackets are attached, position the switch in the rack by
lining up the holes in the brackets with the appropriate holes on the rack.
Secure the switch to the rack with a screwdriver and the rack-mounting screws.
Figure 3-3. Mount the MIL-S3580 in an EIA Standard 19-inch Rack
N
N
N
O
O
O
T
T
T
E
E
E
:
:
:
For proper ventilation, allow at least 4 inches (10 cm) of clearance on the
front and 3.4 inches (8 cm) on the back of the switch. This is especially important
for enclosed rack installation.
Connecting to the Switch
The console port is a male DB-9 connector that enables a connection to a PC or
terminal for monitoring and configuring the MIL-S3580. Use the supplied RS-232
cable with a female DB-9 connector to connect a terminal or PC to the console port.
The console configuration (out-of-band management) allows you to set your switch
to enable a user at a remote console terminal to communicate with the MIL-S3580
as if the console terminal were directly connected to it.