Filter
Top Products
F940GOT-SWD-E/LWD-E INTRODUCTION 1.
1-14
1.3 System configuration
The system configuration to use the GOT is described below.
F940GOT-SWD-E/LWD-E
Data transfer cable FX-232CAB-1 (when the RS-232C connector in the personal
computer is 9-pin type) or Data transfer cable FX-232CAB-2 (when the RS-232C
connector in the personal computer is half-pitch,14-pin type)
Attach a ROM to the F9GT-40UMB, then connect it to a connector provided on the rear
face of the GOT.
FX/FX
2C
Series
A Series (except QnA)
Motion controller
FX
0
/FX
0S
/FX
0N
/FX
2N
/
FX
2NC
Series
Connection cable FX-40DU-CAB *1
It cannot be used when a computer link (RS-232C communication) is used.
PC
Connection cable FX-
50DU-CAB0 for CPU
port connection*1
When the GOT is directly connected to the PLC
:When the GOT is connected via a computer link unit, refer to
Section 2.
Data transfer cable F2-232CAB-1
1
2
3
*1 Connection cables of different length are available.
(Refer to the options in "1.2 Product configuration".)