Filter
Top Products
F940GOT-SWD-E/LWD-E Extension Module 4.
4-2
Operating procedure
a)FX-EPROM-4M
b)F9GT-40UMB
c)User screen/system screen selector switch
d)Extension module interface
1)Attach the FX-EPROM-4M a) in which user screens are saved to
the F9GT-40UMB b).
Pay rigid attention not to bend leads of the FX-EPROM-4M a) nor
touch them with bare fingers.
2)Put upward the user screen/system screen selector switch c).
If this switch is put downward by mistake and data is transferred,
user screens will not be displayed normally.
In this case, put the selector switch c) upward and transfer the
data again.
3)Attach the F9GT-40UMB to the extension module interface d).
Make sure that the power of the GOT has been turned off pre-
liminarily.
4)Turn on the power of the GOT. Then, the screen data will be auto-
matically transferred to the GOT in 2 to 3 minutes.
a)
b)
c)
d)