10
Preparing the projector for operation
Orientation of the projector
Picture size can be set by changing the distance between the screen and the projector.
Front projection
To find the approximate distance
between the projector and screen:
Multiply the width of the screen
✕ 2.0 (max.) , Multiply the width of
the screen ✕ 2.5 (min.).
• Refer to the chart to recom-
mended distances in maximum
zoom and minimum zoom.
Diagonal size
(inch)
23 "
40 "
60 "
80 "
100 "
150 "
200 "
245 "
Height inches
(inch)
13.8 "
24 "
36 "
48 "
60 "
90 "
120 "
147 "
Width feet
(inch)
18.4 "
32 "
48 "
64 "
80 "
120 "
160 "
196 "
Screen
Distance from screen (L) / (approximate)
Maximum
zoom (min.)
(cm)
–
155
236
317
399
602
805
988
(cm)
112
201
305
410
513
774
1034
–
(inch)
–
61.0 "
92.9 "
125 "
157 "
237 "
317 "
389 "
(inch)
44.1 "
79.1 "
120 "
161 "
202 "
305 "
407 "
–
SCREEN
Front projection, ceiling mount
For ceiling mount, you need the ceiling mount
bracket. For more detail, ask your dealer.
• Projected images may appear darker when the
unit is used as a ceiling installation than when it
is used in the tabletop position. This does not
signify a product malfunction.
Rear projection
Ask a specialist for installation. For more detail, ask
your dealer.
Minimum
zoom (max.)
SCREEN
Caution:
• Placing the projector on a carpet reduces ventila-
tion from the fan on the bottom and might cause
problems. Place a hard board or similar item
under the projector to facilitate ventilation of the
unit.
• Place the projector more than 20 in. from the wall
to prevent blocking the intake, exhaust slots and
ventilation of this projector because hot air comes
out of it.
• Do not use the projector under the following
circumstances, which may cause fire or electric
shock.
• in a dusty or humid place
• while the projector is lying sideways or upside
down.
• near a heater
• in a kitchen or oily, smoky or damp place
• in direct sunlight
• with high temperature, such as the closed car
• where the temperature is lower than 41°F or
higher than 95°F
Important:
• Do not put stress on the lens or focus ring, as this
may damage them.
• Keep your room dark while using the projector. The
image cannot be seen clearly in a bright place.
L
(between the screen and head of
the projector)
screen
• The above numbers are the design numbers, and may be slightly different from the actual numbers.
• For rear projection, set IMAGE REVERSE in
INSTALLATION menu to MIRROR. See Page 18.